PET-G GLOOP! 120ML

FULL DISCLOSURE: Some PET, PETG, and Co-Polyesters don’t work with well with Gloop!. This is because all of the crazy complex methods PET and modified PET (co-polymers) are synthesized. Most should work just fine, but some may not. Our team is working on compiling a list of all the best-performing filament manufacturers and we will constantly be updating this page!

A few notes about working with PET Gloop!.

• It’s incredibly sticky. Like sometimes, it likes to glue the cap shut to the bottle if you get it between the seal and the mating lip of the bottle so just try and keep things clean.

• SHAKE WELL! PET Gloop! is an advanced polymer and solvent blend. These shouldn’t separate but it’s a good idea to mix things up if it has been sitting for a while. After shaking, let your PET Gloop! rest for about a minute before opening. This helps keep that seal clean!

• Use lots of Gloop! This will help ensure a strong bond. Any ooze out should be cleaned with a razor blade after it cures!

• Clamps are your friend. Gloop! is strong, but ensuring the mating surfaces are pressed as close as possible and mated together will make the bond stronger.

• *Cure times vary, when in doubt, give it lots of time to cure. Unlike our PLA Gloop! PET Gloop! can take an hour or more to cure. This means the bond can fall or be pulled apart more easily until the Gloop! fully cures. So be careful!!!